Marker Lights!

12v Marker lights are being used. They are fed thru 24v relays installed above the rear closet on a hinged access door. This will make it easier to add or trouble shoot later without breaking your back to get to them. Everything is ran in its own conduit for the same reason. This will all be covered in insulation later. The marker lights are mounted on hardwood mounts. These are hard enough to tap for the conduit connections, and are fiber glassed into the caps.The hole is drilled at an angle since water will not run uphill. Just need to remember which is left, and which is right. Only a small hole is drilled thru the caps for the wires and screws. With the small hole sealed with silicone, and the marker lights gasket we should be free from the leaks.

After this is all done we will have a total of 5 relays. Right turn, Left Turn, Stop, Marker, and Back up lights. These will also be used for the "TOAD" vehicle. There is also a junction box in the center of the bus, and in the front. Just in case we need to add more things later.